|
|
|
|
|
Vulcanized rubber
with other technologies such as microwave sulfide (UHF)
technology, LCM is a prominent feature of the system.
Primarily in its quality, excellent handling, a high cure
rate and broad applicability (including color can be used
for curing rubber), and :
¡ó Since curing salt have excellent heat transfer properties
of vulcanized rubber in the entire cross-section profile
is completely homogeneous;
¡ó Vulcanization, immersed in the high-density salt under
uniform pressure profile rubber curing minimal deformation;
¡ó Salt inhibition of the formation
of vulcanized rubber surface low, after the rubber processing
technology LCM has good mechanical properties;
¡ó Salt vulcanized rubber and less porous surface smoothness;
¡ó Profiles of the rubber material
to strengthen the internal (if any) does not have any
impact on the vulcanization.
¡ó Compared with other curing techniques, the following
characteristics LCM technology, directly or indirectly,
to reduce the cost of production of rubber profiles :
¡ó Easy to operate;
¡ó If not added to rubber compounds UHF technology needs
special additives;
¡ó Profiles
section of rubber can be dealt with more simply and thinner
design;
¡ó LCM curing rate
in the same system equipment more quickly;
¡ó Less energy consumption. In the use of natural gas or
gas as the main source of heating, low energy costs in
particular;
¡ó Solid waste
to the main impurity. Salt rubber fully immersed, the
less gas is irritating odor
However, the traditional operating system LCM, the rapid
movement of the rubber profile will bring out the molten
salt water used to wash, clean water is often not treated
heavily on direct emissions, which cause environmental
pollution. DURFERRIT introduced a new LCM system, including
curing salt BaiNa system solutions technology and equipment
-- the recovery and recycling of curing salt. fundamental
to the elimination of environmental pollution! |
|
 |
| |
|
| |
|
