The extruder has two different types depending on the drive. These are Direct extruder and Bowden extruder. Direct extruderIn direct extruders, the hot end and cold end are simply attached together. In this setup, the filament goes straight down through the cold end and into the hot end. One of the ...

The rubber hot air oven is an electrical device which is used in the various industries. The device uses hot dry steam for the sterilization of the products used in the industries. The industrial ovens have different types which are used for the different applications like Annealing, Curing, Heating...

With the emergence and wide application of rubber extruder machine, the application range of hot feed extruders is gradually shrinking. Rubber extruders have developed from hot feed to cold feed, and cold feed pin extruders have become the mainstream of development. Pin extruders have been widely us...

You might be surprised to know that the rubber in your tires and so many other modern uses begins as a white, liquid type substance called latex that is derived from certain plants. If you cut a dandelion stem, for instance, you’ll see latex dripping from the stem. Theoretically, rubber could be mad...

The head of the rubber extruder machine is installed on the rubber extruder. The correct installation of the rubber extruder head is the basic condition to keep the rubber extruder in good working condition. The correct installation of the rubber extruder head is crucial . 　　 The following are the i...

1. Feeding section 　　It is also called the solid conveying section, which starts from the feed port until the rubber melts. After the rubber material enters the feed port, under the push of the rotating screw, the rubber material moves relatively between the spiral groove and the inner wall of the c...

The steps of rubber extruder debugging are as follows: 　　 1. The temperature control check should be done before starting to make sure that the temperature control is normal, the instrument is normal, and the cooling water circuit is unblocked. 　　2. The screw, barrel and die of the rubber extruder n...

All extrusion processes require the generation of pressure within the material to be extruded. When materials are put under pressure heat is generated. This cannot be avoided but different extrusion types generate different amounts of heat. There are basically three different types of rubber extrude...

The rubber extruder barrel is normally supported in some way by the frame on which the whole system is mounted. If the extruder barrel moves, and this can happen sometimes even when the barrel is supported, it can indicate that the extruder shaft is bent, the barrel is misaligned, or a combination o...

Twin screw rubber extruder machine has three different extrusion systems: 　　1, non-intermeshing co-rotating twin screw extrusion system 　　 In the non-intermeshing twin-screw extrusion system, in addition to the movement form towards the machine head, there are also many flow modes for the material....

Many types of rubber extruder machine are used in the food industries and several designs are possible for a food extruder. The lots of commonly used extruder consists of the flighted screw(s) or worm(s) rotating within a sleeve or barrel to be termed as the screw extruder. However, the piston type ...

The rubber extruder play an important role in the production of rubber products. Many of our common rubber products are extruded by rubber extruders. When we purchase a rubber extruder, we must choose the configuration and model of the rubber extruder according to the type of product. When we purch...