"Asia Rubber Expo & India Rubber Technology Exhibition 2020" is jointly sponsored by Aakar Exhibition Company and Zhonglian Rubber Co., Ltd. The exhibition will be held at the Chennai Trade Center...Read More
Before starting the plastic extruder, we must first check whether the circuit of the plastic extruder has leakage and whether the rotating part is exposed. Then we start to heat up the equipment. Do not touch the heating system and the screw barrel of the equipment with your body during the heating process. When the temperature of the equipment reaches the temperature we set, you can start the equipment and fill the equipment with raw materials.
The operator is not allowed to put any part of the body into the feeding system of the equipment during production. In addition, female operators need to issue and distribute safety helmets to operate the equipment. During production, we must monitor the temperature of the equipment at all times to ensure the normal operation of the equipment and the normal extrusion of products. When the temperature of the equipment is too high, the fan will be started to cool down the screw barrel. At this time, we need to stay away from the air outlet of the equipment and keep a distance from the rotating fan blades.
If the extruder needs to be shut down, we need to fully extrude the raw materials in the extruder screw barrel, and the extruded material needs to be cooled before it can be touched by hand to avoid burns.